Inhoudsopgave
Advertenties
EN
You can change the machine to a well groomed
edger for edging patios, driveways and walkways or
other areas.
1.
Stop the machine.
2.
Push on the edge button and rotate the trimmer
head until the guard and the shaft are parallel.
3.
Unlock the cam lever and turn the trimmer head
90 degrees until the trimmer head locks into
position.
4.
Lock the cam lever.
4.9
OPERATION TIPS
Figure 14.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• First, remove the battery pack.
• Then, remove the grass.
4.10
CUTTING TIPS
Figure 15.
• Tilt the machine towards the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
5
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
NOTE
WARNING
WARNING
IMPORTANT
English
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of
the initial manufacturer.
5.1
GENERAL INFORMATION
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in a cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
5.2
CLEAN THE MACHINE
• Clean the machine after each use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents like
"glass cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
• Do not spray water onto the motor and electrical
components.
5.3
REPLACE THE SPOOL
Figure 16 - 18.
1.
Simultaneously press the tabs on the sides of the
trimmer head.
2.
Pull and remove the spool cover.
3.
Remove the spool.
4.
Replace with a new spool.
Make sure that the cutting line is in the guide slot
on the new spool, and is extended approximately 13
cm. before you install the new spool.
5.
Put the end of the cutting line through the eyelet.
6.
Extend the cutting line to release it from the guide
slot in the spool.
7.
Push the tabs and install the spool cover onto the
spool housing.
6
IMPORTANT
IMPORTANT
IMPORTANT
NOTE
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
