Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8.
Push the spool cover until it clicks into position.
5.4
REPLACE THE CUTTING LINE
Figure 19 - 21.
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 1.65 mm
diameter.
1.
Cut a piece of cutting line approximately 3 m
long.
2.
Bend one end of the line approx. 6 mm.
3.
Insert the line into the anchor hole of the spool.
4.
Wind the cutting line around the spool tightly in
the indicated direction.
IMPORTANT
Failure to wind the line in the indicated direction will
cause the trimmer head to operate incorrectly.
5.
Put the cutting line in the line slot.
6.
Do not wind the cutting line beyond the edge of
the spool.
6
TRANSPORTATION AND STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
6.1
MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2
STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot access the machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
English
NOTE
NOTE
7
TROUBLESHOOTING
Problem
Possible
Cause
The ma-
No electrical
chine
contact be-
does not
tween the ma-
start
chine and the
when the
battery pack.
trigger is
pushed.
The battery
pack is deple-
ted.
The lock-out
button and trig-
ger are not
pushed at the
same time.
7
Solution
1. Remove battery
pack.
2. Check contact and
install the battery
pack again.
Charge the battery
pack.
1. Pull the lock-out
button and hold it.
2. Pull the trigger to
start the machine.
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
