Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.4
ATTACH THE AUXILIARY HANDLE
Figure 6 - 7.
1.
Remove the knob from the handle.
2.
Attach the auxiliary handle on the shaft.
3.
Set the auxiliary handle in the comfortable
position.
4.
Tighten the auxiliary handle with the knob.
4
OPERATION
IMPORTANT
Before you operate the machine, read and
understand the safety regulations and the operation
instructions.
WARNING
Be careful when you operate the machine.
4.1
INSTALL THE BATTERY PACK
Figure 8.
WARNING
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1.
Align the lift ribs on the battery pack with the
grooves in the battery slot.
2.
Push the battery pack into the battery slot until
the battery pack locks into place.
3.
When you hear a click, the battery pack is
installed.
4.2
REMOVE THE BATTERY PACK
Figure 8.
1.
Push and hold the battery release button.
2.
Remove the battery pack from the machine.
4.3
START THE MACHINE
Figure 9.
1.
Push the lock-out button and pull the trigger.
4.4
STOP THE MACHINE
Figure 9.
1.
Release the trigger to stop the machine.
4.5
ADJUST THE LENGTH OF THE CUTTING
LINE
Figure
English
The machine has an auto-feed head. If the cutting
line does not automatically advance, it can be
tangled or empty.
1.
Start the machine and keep 3s. Release the
trigger until the machine totally stops.
2.
Repeat the above step until you can hear the
line-cutting noise.
The line will extend approximately 1 cm with each
stop and start of the switch trigger until the line
reaches the cut-off blade and the cut-off blade cuts
the excess length.
Do not pull or release the trigger too fast.
It will damage the machine if you hit the head to try
to advance the line.
4.6
LINE CUT-OFF BLADE
Figure 1.
This trimmer is equipped with a line cut-off blade
on the guard. The line cut off blade continuously
trims the line to ensure a consistent and efficient cut
diameter. Advance line whenever you hear the engine
running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep the line long enough to advance properly.
4.7
ADJUST THE LENGTH OF THE SHAFT
Figure 10.
You can adjust the length of the shaft to operate the
machine easily.
1.
Stop the machine.
2.
Unlock the cam lever and move the lower shaft to
the desired position.
3.
Lock the cam lever.
4.8
CHANGE TO THE EDGING MODE
Figure 11 - 13.
5
NOTE
NOTE
NOTE
NOTE
NOTE
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
