Inhoudsopgave
Advertenties
6. Before operation
Unpack the appliance and remove the adhesive tape.
Use a mild cleaning agent to remove any adhesive
residues.
Dispose of the expanded polystyrene padding sepa-
rately from the other packaging.
Clean the inside of the appliance and the fittings with
lukewarm water and mild cleaning agent and allow to
dry
Follow the cleaning instructions in the "Cleaning and de-
frosting" section of the user manual.
6.1. Changing the door hinge
The freezer is supplied with a door hinged on the right-
hand side. If you want to change the opening direction,
proceed as described in the user manual, section "Chang-
ing the door hinge".
6.2. Fitt ing the spacers
Fig. 3 – Attaching the spacer
Mount the spacer (11) at the height of the upper fixing
plate (see Fig. 3) on the back of the appliance on the cool-
ing ribs.
Insert each spacer (11) in the vertical position up to the re-
T
cess marked
between two cooling ribs and turn it 90° to
the horizontal position. This prevents the condenser from
coming into direct contact with the wall.
6.3. Sett ing up the appliance
NOTICE!
Possible material damage!
Risk of damage to the appliance due to improper han-
dling
Install the freezer in a dry and ventilated room. The
room should be around 4 m², so there will be sufficient
air volume available if the cooling system becomes
damaged.
Take the space requirements into consideration when
setting up the appliance:
To ensure adequate ventilation, a minimum clearance
of 15 cm to the top, 5 cm to the sides and 7.5 cm to the
back must be observed. To be able to open the freezer
door (4) fully, the following room dimensions must be
available (see Fig. 4).
50
The appliance is suitable for climate classes T and SN
(see the type plate). The cooling performance of the
appliance is guaranteed at ambient temperatures from
10°C to 43°C. If temperatures deviate from this range,
the appliance performance may be reduced.
Do not expose the appliance to extreme conditions.
Avoid:
– high humidity or wet conditions
– extremely high or low temperatures
– direct sunlight
– naked flames.
ca. 7,5 cm
5 cm
max. 225°
ca. 105 cm
Fig. 4 – Necessary room dimensions
Move the appliance to a suitable location.
ca. 15 cm
ca. 84 cm
Fig. 5 – Minimum room height, aligning the appliance
Level the appliance by compensating for any uneven-
ness in the floor by screwing in the appliance feet (7)
accordingly (see Fig. 5).
Level the freezer with a spirit level.
5 cm
ca. 116 cm
Advertenties
Hoofdstukken
Inhoudsopgave
