Inhoudsopgave
Advertenties
A 0002 / 2002EA
When all the chain links have been sharpened with the previously set angle, make the necessary adjustments for the chain
links with the opposite angle and sharpen them as well.
As you did with the first half of the chain, be sure to lower the motor housing ④ so that the sanding disc ⑮ brushes the
chain links and lock it in place. Follow all of the previously described steps to check everything before plugging in the unit
and turning it back on.
Remember to turn off the machine and unplug it if you need to make any adjustments
After you repeat all of the steps under sharpening, your chain is ready to be mounted on your
saw.
Depth gauge
After sharpening, measure the depth jig space. There should always be a space between the chain
link and the reamer. Otherwise, the chain will not cut.
If necessary, the reamer should be filed according to the characteristics of your chain.
E. CARE AND MAINTENANCE
Clean the product only with a dry or slightly damp, lint-free cloth.
Do not use abrasive cleaners to clean the unit.
Keep the sharpener clean and free of dust, metal debris, and dirt.
Check the wheel before each use to make sure it is not damaged. Do not use the wheel if it is chipped, cracked or worn. You
can check the wheel for cracks invisible to the naked eye by hanging it through the center hole and tapping it with a non-
metallic object (eg screwdriver handle). If it is in good condition, it will produce a metallic sound. A dull sound indicates a
crack or break.
Replace the wheel when it is worn.
Replacing the grinding wheel
1. Raise the Engine Casing ④ and lock it in the up position by tightening
the Screw ⑦.
2. Remove the screws holding the grinding wheel cover, set the cover
aside.
3. Unscrew the up pressing valve (#5) in place.
4. Install the new wheel on the pressure plate, making sure it fits
properly.
Note: Do not use a grinding wheel if it chipped, cracked, or worn. You
can check if the wheel has cracks not visible to the human eye by
hanging it up by the central hole and tapping it with a non metal object
(ie: screwdriver handle). If it is in good condition it will produce a
metallic sound. A dull sound indicates a crack or break.
5. Replace the grinding wheel cover.
Never operate tool without the grinding wheel cover in place.
J. SPECIFICATIONS
- Material : Nylon
- Power : 230V/50Hz (2m length cable ) 65W
- R/min: 7000 rpm
- Grinding wheel Ø 100 x 32mm
The European directive 2012/19/EC about electronic and electric waste, requires that you can't throw away defective
domestic appliance with common waste. Used device has to be collect separately to optimize the recuperation rate and the
recycling of the materials to reduce the impact on the health and the environment.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or
by persons lacking in experience or knowledge, unless they are supervised or instructed on the use of this apparatus by a
person responsible for their safety.Children should be supervised to ensure they do not play with this appliance.
up pressing valve
Disque abrasif ⑮
Grinding wheel ⑮
(#5)
Advertenties
Inhoudsopgave
