Advertenties
Beschikbare talen
Beschikbare talen
GB
8 COMMISSIONING
8.1
Charging the rechargeable battery
Observe the temperature range for charging, see
technical data.
NOTE For detailed information, see the sep-
arate operating instructions for the rechargeable
battery and the charger:
■
Operating manual 441630: Li ion recharge-
able battery B150 Li (B05-3640G), B200 Li
(B05-3650G)
■
Operating manual 441633: Charger C130 Li
(C05-4230)
8.2
Fitting and removing the rechargeable
battery (10)
Inserting the battery (10/a)
1. Push the battery (10/1) into the battery slot
(10/2) until it engages.
Pulling out the battery (10/b)
1. Press and hold the unlocking button (10/3) on
the battery.
2. Pull out the battery.
9 OPERATION
WARNING! Danger if assembly is not
carried out completely! Use of an incompletely
assembled appliance can result in serious injury.
■
Operate the appliance only when it is fully as-
sembled!
■
Do not insert the battery into the appliance
until it is fully assembled!
9.1
Switching the appliance ON and OFF
(11)
Switching on the appliance
1. Bring the appliance into working position.
2. Push unlocking switch (11/1) in the direction
of the open padlock.
3. Push ON/OFF lever (11/2) as far as it will go
and hold it there. The brushcutter starts.
4. Push speed switch (11/3) in the desired di-
rection:
■
"FAST" (11/a): The brushcutter runs fast.
■
"SLOW" (11/b): The brushcutter runs
slowly.
Switching off the appliance
1. Release the ON/OFF lever.
32
9.2
Checking the battery charge status
The charge status indicator is located on the bat-
tery.
NOTE For detailed information, see the sep-
arate operating instructions for the rechargeable
battery and the charger:
■
Operating manual 441630: Li ion recharge-
able battery B150 Li (B05-3640G), B200 Li
(B05-3650G)
■
Operating manual 441633: Charger C130 Li
(C05-4230)
9.3
Prolonging the cutting line during
operation (12)
The cutting line becomes shorter and frays during
operation.
1. Tap (12/a) spool head (12/1) on the lawn
from time to time at high speed. This unwinds
a piece of new cutting line from the spool and
cuts off the used end of the cutting line
(12/2).
Risk of injury! Do not touch the sharpening
line cutter!
10 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (13 – 14)
■
Tilt the appliance slightly forwards (approx.
30°) to mow with the tip of the cutting line.
Walk forwards slowly.
■
When mowing, swivel the appliance evenly to
the right and left.
■
Long grass must be mown in several passes.
Always work from top to bottom (13).
■
The appliance cuts best at very high speed.
Therefore do not overload the appliance by
cutting long grass.
■
If the appliance is overloaded in long grass,
the cutting line will block. Lift the appliance
immediately to relieve the load. Irreparable
damage can otherwise be caused to the mo-
tor.
■
Do not work with the appliance directly
against hard obstacles (e.g. Walls) and mow
from the side. This protects the cutting line
(14).
■
Keep the appliance away from delicate
plants.
Measures if the blade jams
Thick vegetation, young trees or undergrowth can
block the blade and bring it to a stop.
Commissioning
GT 4235.2
Advertenties
