Advertenties
Power tool use and care
▶ Do not use cut-off wheels for grinding.
▶ Tighten the accessory tool and flange securely. If the accessory tool and flange are not tightened
securely, the accessory tool may work loose from the arbor due to the braking effect of the motor after
switching off.
▶ Secure the workpiece. Use clamps or a bench vise to hold the workpiece in position. The workpiece is
thus held more securely than by hand and both hands remain free to operate the product.
▶ Grinding wheels must be stored and handled carefully in accordance with the manufacturer's instructions.
Additional notes on the use of the guards
To avoid the risks below always use the correct guard, see the section headed: "Suitability of wheels for the
equipment used".
▶ If the Standard guard with front cover is used for surface grinding, the guard can touch the workpiece
and thus lead to loss of control.
▶ If a wire brush of a thickness exceeding the maximum permissible thickness is used, the wires can snag
on the guard and break.
▶ If the standard guard is used for cutting off metal with an abrasive cut-off wheel, there is an increased
risk of exposure to sparks and particles and to wheel fragments if the wheel breaks.
▶ If the standard guard is used with or without front cover for cutting or for grinding concrete or masonry,
there is a higher dust load and an increased risk of losing control of the product, which can lead to
kickbacks.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a hand-held electric angle grinder. It is designed for cutting, grinding and sanding
metal and mineral materials without use of water.
The tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its rating plate.
•
The power tool may be used for cutting, slitting and grinding mineral materials only when equipped with
the corresponding guard and front cover.
22
English
1
Arbor lockbutton
@
Steadying rib for set-down
;
On/off switch
=
Speed adjustment thumbwheel
%
Side handle
&
Pin wrench
(
Clamping nut
)
Abrasive cut-off wheel/abrasive grinding disc
+
Clamping flange with O-ring
§
Guard
/
Clamping lever
:
Adjusting screw
∙
Arbor
$
Keyed locating lug
£
Threaded socket for side handle
|
2177169
*2177169*
Advertenties
