Advertenties
1.Press the switch-on interlock.
2.Press the on/off switch.
Sawing along a line
1.Secure the workpiece to prevent movement.
2.Make sure that the saw blade has clearance underneath the workpiece.
3.Bring the front edge of the base plate into contact with the workpiece.
4.Switch on the circular saw.
5.Guide the circular saw along the cutting line on the workpiece at a suitable speed.
Sawing with the plunge function
In plunge cutting, the saw blade is lowered into the workpiece at a point suitable for starting the cut.
The plunge function can be used with the saw blade set to any cutting angle.
To reduce the risk of kickback, secure a stop piece to the workpiece directly behind the base
plate.
1.Set the cutting depth to 0.
2.Set the circular saw flat on the workpiece.
3.Bring the rear mark on the base plate into alignment with the cutting line.
4.Release the cutting depth lock.
5.Press the saw against the workpiece and against the stop.
6.Switch on the circular saw.
▶
The saw blade moves down.
7.Retighten the cutting depth lock as soon as the desired cutting depth is reached.
8.Make the cut.
Switching the power tool off
1.Release the on/off switch.
2.Wait until the saw blade has stopped rotating.
Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a
power outlet can lead to severe injury and burns.
▶
Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone
as they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries
including burns.
▶
Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that
they all function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
*314714*
4
314714
21
Advertenties
