Inhoudsopgave
Advertenties
Translation of the original instructions
STARTPACK TRUCK & STARTPACK TRUCK MOBILE
USE AS A 12V DC POWER SUPPLY (P.58-59)
The cigarette lighter plug is protected by an integrated 20 A circuit breaker. In the event of an
overheating due to an overcharge, the circuit breaker will stop the power supply.
This device can be used as a 12V DC power supply for many electrical debices such as radio, fan, electrical tools, camera, TV...
• Turn the knob (6) to the OFF position.
• Plug the cigarette lighter socket (12) of your electrical device in the Booster (10) (cable not included).
• Turn the switch (6) onto the 12V position.
The output is protected by a 20A thermal circuit-breaker.
Estimated autonomy of STARTPACK TRUCK as a 12 V DC power supply
Device
Fluorescent cellular light
Radio, Fan, Echoprobe
Videocamera, light spot
Power tool, drying pump
Air Compressor, Car vaccum cleaner
INTERNAL BATTERIES TESTERS (Mobile version only) (P.58-59)
To be representative, the battery voltage must be measured with the booster disconnected of any
charge (on the clamps and on the cigarette lighter plug) and ten minutes after the previous start or the
stopping charge in order to the battery voltage is stabilised.
This device contains a built-in battery tester to view the charge status of both internal batteries.
Use the three-position test switch (4) located on the control board : in position 0 the display is off. The position I
indicates the voltage of the first battery, the position II indicates the voltage of the second battery.
The result appears on the display (5) : if the no-load voltage is between 0 and 10 V, the battery is on a critical state (in
this case refer to the part «Batteries replacement»). Above 12.5 V the battery is in a good state of charge. Between
these 2 values the battery must be recharged.
LED LIGHT (Standard version only)
The Startpack Truck standard is equipped with a lamp incorporated by 7 high brightness LED. It lights up with the
«LIGHT» button (2) located nearby.
PROTECTION (P.58-59)
This device is designed with many protection features :
• ON/OFF battery breaker : protection against overvoltage when clamps are connected on the battery.
• An alarm beep in case of reversed polarity and misuse.
• Copper cable 2 x 1.80m, ø 25mm² with 600A insulated clamps.
• 300A fuse located on the plastic case. A replacement duse is located at the back of the device (ref. 054561).
• An orange indicator (1) flash after a start means that the bosster must be recharged.
TROUBLESHOOTING
Troubleshooting
The orange LED of the device is flashing.
The device beeps and the red LED is on. The device detects a polarity reversal.
Sparks appear when the clampsmake
contact with the battery terminals.
The unit can not start the vehicle.
14
Estimated consumption (in watts)
4
9
15
24
80
Causes
At some point, the voltage of the internal
battery has dropped below 12V following
a start or a heavy consumption.
The switch is on 12V or 24V.
The wrong voltage is selected at the switch.
The position of the negative and positive
clamps on the battery terminals is
incorrect (polarity reversal).
The switch is in the OFF position.
Estimated automomy (in hours)
69
30
18
11
3
Solutions
Charge the device after each use. The orange
indicator is still flashing more than 10 minutes after
the beginning of the charge.
Check the battery polarity.
Switcht machine off before connecting the clamps
to the battery.
Check that the selected voltage match the voltage
of the vehicle battery.
Check the battery polarity.
Position the switch on the desired voltage.
EN
Advertenties
Inhoudsopgave
