Download Inhoudsopgave Inhoud Print deze pagina

Before You Change The Preset Programmes; Programming In 7-Day Mode; Use And Buttons To Alter - Danfoss TP7000-RF Installatiehandleiding

Verberg thumbnails Zie ook voor TP7000-RF:
Inhoudsopgave

Advertenties

The unit is now in RUN mode (colon ashes in
GB
display) and the heating will operate according
to the preset programmes.

Before you change the preset programmes

Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG until
Event 1 ashes in the display.
1
1 2 3 4 5

Programming in 7-day mode

(separate programmes for each day of the week)
a) Press PROG until Event 1 ashes, then press
DAY to move from current day to Day 1.
b) Amend the time and temperature as
follows:
i)
Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
ii)
Use
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next Event.
iv) Repeat steps i,ii & iii above for Events 2,
3, 4, 5 & 6.
10
This unit is in 7-day mode and you can programme
di erent settings for each day of the week (see page 10-
11).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 11).
buttons to alter
and
1

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Tp7000Tp7000aTp7000mTp7000maTp7000-m 24

Inhoudsopgave