Advertenties
Status
One (1) LED shows yellow
One (1) LED quick-flashes red
Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than
three seconds. The system does not detect a potential malfunction of the battery due to misuse, for
example battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
Technical data
The product has 2 modes for the speed stages. Small fasteners can be tightened with the lower of
the speed stages.
Product generation
Rated voltage
Weight in accordance with EPTA Procedure 01, without
battery
Rated speed under no load
Impact speed
Storage temperature
Ambient temperature for operation
Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
*2284954*
2284954
Meaning
The Li-ion battery and the product in which it
is inserted are not compatible. Consult Hilti
Service.
The Li-ion battery is locked and cannot be
used. Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of
health did not complete. Repeat the procedure,
or consult Hilti Service.
If a connected product can still be used, the
remaining battery capacity is below 50 %.
If a connected product can no longer be used,
the battery has reached the end of its useful life
and has to be replaced. Consult Hilti Service.
SIW 8-22
01
21.6 V
2.4 kg
Mode I
0 /min ... 1,250 /min
Mode II
0 /min ... 1,500 /min
Mode I
0 /min ... 2,500 /min
Mode II
0 /min ... 2,950 /min
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
21.6 V
See the end of these operating in-
structions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
20
Advertenties
