Inhoudsopgave
Advertenties
LX
/LX
A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
file folders, X-rays or plastic other than noted above
* A4 (70g), paper at 220V-240V, 50/60 Hz, 2.5 Amps (LX200), 4.5 Amps (LX210), 5.0 Amps (LX220); heavier paper, humidity or other than rated voltage may
reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day, 25 credit cards. Fellowes SafeSense
operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
WARNING! IMPORTANT SAFETY INSTRUCTIONS – Read before using!
BASIC SHREDDING OPERATION
LX200
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX210
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX220
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
2
LX
F.
A.
B.
G.
C.
D.
E.
are covered in the instruction manual. Read the
entire instruction manual before operating shredders.
Keep away from children and pets.
Keep hands away from paper entry. Always set to off
or unplug when not in use.
top opening, switch to Reverse (
aerosol lubricants on or near shredder. DO NOT USE
"CANNED AIR" OR "AIR DUSTERS" ON SHREDDER.
Vapors from propellants and petroleum based
under shredder head.
disassemble shredder. Do not place near or over
heat source or water.
F.
A. SafeSense
G.
Technology
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
Paper shred size: Mini-Cut, 4mm x 12mm
Maximum Sheets per pass:
LX200 - 12*, LX210 - 16*, LX220 - 20*
Maximum Paper entry width: 230mm
Switch (F) that must be in the ON ( ) position
to operate shredder. In case of emergency,
move switch to OFF (O) position. This action
will stop shredder immediately.
under shredder head.
) to back out
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed
Energy converters, transformers, or extension
cords should not be used with this product.
cards with sound chips or batteries.
servicing.
ENGLISH
®
shredders are designed to be
®
PAPER OR CARD
1
Plug in and put disconnect power
switch in ON (I) position
2
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
Advertenties
Inhoudsopgave
