Inhoudsopgave
Advertenties
Preparing the Device for Operation
Unpack the device. Wipe its casing with a cloth dampened with water, then
wipe dry. Detach the water tank (see Fig. F). Rinse and dry the water tank and
all the nozzles as described in the "Cleaning and Maintenance" section ("Daily
care").
Charging the Device
Note. The power adapter is not included in the package. You can use any power
supply (adapter, portable charger, etc.) as long as it ensures 5.0 V (DC) , 2.0 A
power parameters.
Connect the device to a power supply as shown in Figure D. Statuses of the
battery charge indicator (6) while charging:
The device is charging: the indicator is blinking;
The device is fully charged: the indicator is lit up steadily.
When charging is complete, disconnect the device from the power supply,
detach the cable (12) and close the USB port (8) by firmly inserting the cover.
Statuses of the battery charge indicator (6) while in operation:
Less than 10 % – the indicator is blinking, the device does not turn on;
10–100 % – the indicator is lit up steadily.
Attach one of the replaceable nozzles (13–15) to the casing by pushing it until it
clicks into place. The nozzle can rotate 360°.
Intended Purpose of the Irrigator Nozzles (see Fig. C):
(13) – standard nozzle for removing food debris and plaque;
(14) – orthodontic nozzle for braces and dentures;
(15) – nozzle for cleaning periodontal pockets.
Fill the water tank (2) as shown in Figure G. Fasten the cap of the water filling
opening (10). Afterwards, select the operating mode of the device.
Selecting the Operating Mode of the Device
Note. To select the operating mode, point the outlet of the nozzle in a safe
direction so that the jet of water does not damage your surroundings and you
can see the mode selection panel (5).
aeno.com/documents
15
Advertenties
Inhoudsopgave
