Advertenties
GB
"Software"
Shows the firmware version.
"Program Info"
Shows current settings such as the total weekly
mowing time.
"Failures"
Shows the fault messages that last occurred with
date, time and fault code.
9 MAINTENANCE AND CARE
CAUTION!
Risk of injury
Sharp-edged and moving appliance parts
can lead to injury.
■
Always wear protective gloves during
maintenance, care and cleaning
work.
9.1
Cleaning
IMPORTANT!
Danger from water
Water in the automatic lawn mower and
in the base station leads to damage on
electrical components.
■
Do not spray the automatic lawn
mower and base station with water.
Clean the automatic lawn mower
CAUTION!
Danger of injury due to the cutting
blade
The cutting blades are very sharp and
can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do
not get into the cutting blade.
Once a week, carry out the following:
1.
Switching off the appliance.
2. Wipe off the surface of the housing with a
broom, a brush, a damp cloth or a fine
sponge.
3. Brush off the underside, mower deck and cut-
ting blade with a brush.
4. Check the cutting blade for damage. If neces-
sary, replace the following: see chapter 9.3
"Replacing the cutting blades", page 50.
50
Cleaning the base station
1. Regularly remove grass residues and leaves
or other objects out of the base station.
2. Wipe off the surface of the base station with
a damp cloth or a fine sponge.
9.2
Regular checks
General checks
1. Once a week, check the whole Installation for
damage:
■
Machine
■
Base station
■
Boundary cable
■
Low voltage cable
■
Transformer with power cable
2. Replace defective parts by original spare
parts from AL-KO or have them replaced by
an AL-KO service centre.
Check the rollers can move freely
Once a week, carry out the following:
1. Carefully remove grass residues and soiling
from the areas around the rollers. Use a
broom and cloth for this.
2. Check that the rollers run freely and that they
can be steered.
Note: If the rollers do not move freely or can-
not be steered, have them replaced by an
AL-KO service centre.
Check the contact surfaces on the automatic
lawn mower
1. Use a cloth to remove soiling and then lightly
grease with contact grease.
2. Rub any charring on the contact surfaces
down to the bare metal surface with fine sand
paper and then lightly grease with contact
grease.
Check the charging contacts of the base
station
1. Disconnect the mains plug.
2. Press the charging contacts in the direction
of the base station and release them. The
charging contacts must spring back into the
initial position.
Note: If the charging contacts do not spring
back, have them replaced by the AL-KO ser-
vice centre.
9.3
Replacing the cutting blades
Worn or bent cutting blades must be replaced.
Maintenance and care
Robolinho 1100/110
Advertenties
