Inhoudsopgave
Advertenties
When used in your home:
Slide the switch on the backside of the bottle warmer into the position 230VAC
and use the 230V mains power cable when warming the water of the bottle
warmer.
When used in your car:
Slide the switch on the backside of the bottle warmer into the position 12VDC and
use the included 12V cable with car plug when warming the water of the bottle
warmer.
Do not use while driving, please put the car aside the road but keep the engine
running (high power consumption of 5A). Only use the provided 12V cable.
1. Place the bottle warmer on a stable surface, out of reach of child-
ren. make sure that the settings knob is turned counter clockwise,
into the position
2. Fill the reservoir of the bottle warmer up to the short line with tap
water.
3. Put the pacifiers you'd like to sterilize down into the bottle warmer.
4. Place the steam cover onto the bottle warmer to both keep the heat
inside and to prevent hot splashes from harming you.
5. Insert the plug into a 230Volts wall socket.
6. Turn the settings knob clockwise to position MAX.
7. After about 1,5 minute, the water is boiling.
8. Leave the water boiling until after about 1,5 minute the thermostat turns-off
the heating element (the blue light around the settings knob goes off).
9. Turn the settings knob counter clockwise to position OFF and remove the
power plug from the mains.
10. Attention: the steam cover may become very hot. First wait several minutes
until the temperature has decreased sufficiently for you to safely remove the
steam cover. Use kitchen pliers (not included) to remove the pacifiers from the
bottle warmer.
DC12V or AC230V
TO STERILIZE PACIFIERS (ON 230V ONLY)
OFF.
KEEP IN MIND THAT THIS STEAM COVER
MAY BECOME VERY HOT DURING USE.
17
Advertenties
Inhoudsopgave
