Advertenties
Fig. 1
X
Fig. 2
Z
Fig. 3
Fig. 4
Y
INSTALLATION
M
N
- 61
ADAPTATION FOR PELLET LOADING
SCREW SYSTEM (optional)
The boiler is prepared, on the back (X) and on the right side
(Y), to use an external pellet tank eqipped with a feeding screw.
ATTENTION: the boiler must be positioned at least 30 cm
from the wall behind it
To install the system, proceed as follows:
N.B.:
before starting, turn the boiler off and disconnect the elec-
tricity supply wire.
Fig 1 - 2 -3
• Remove the pre-cut cover on the back (X - fi g. 1) or on the
right side (Y - fi g. 4), and remove the cover screwed on the
pellet tank (Z - fi g. 2), replacing it by the fl ange connection for
the fl exible hose contained in the package of the external tank
(M -fi g. 3).
• The fl exible pellet feeding pipe must be connected to the
fl ange (N) (see system technical diagram).
Fig 4 - 5
• Insert the proximity sensor into the hole on the right side of
the boiler (N - fi g. 4), removing the pre-cut cover fi xed by two
screws.
Fig. 5
-
Advertenties
