Inhoudsopgave
Advertenties
Boil the water
Place the filled kettle on the base. The device is in standby mode and the pre-selection temperature
100°C illuminates.
Press the start / stop button
. This will now glow blue and the water begins to be heated. As soon as
the water is boiling, a signal tone will beep and the device automatically switches to standby mode.
You can interrupt the boiling process at any time by pressing the start / stop button
again.
In order to switch off the kettle, hold down the start / stop button
for approximately 3 seconds and
the control lights will go out.
Temperature pre-selection
The kettle gives you the possibility of heating water to a desired temperature, e.g. one that matches
your favourite type of tea: 70°C for fine green tea types or 90°C for Oolong tea or white tea. Observe
the respective manufacturer's specifications.
Place the filled kettle on the base and the device is in standby mode.
Set the desired temperature (60, 70, 80 or 90°C) by pressing the respective button. Then press the start
/ stop button
. This will now glow blue and the water begins to be heated.
A signal tone will beep once the desired temperature has been reached.
Please understand that for technical reasons the temperature may differ a few degrees from the set
temperature.
Keep-warm function
Set the desired temperature by pressing the respective button. Then press the keep-warm button
.
This will now glow blue and the water begins to be heated.
A signal tone will beep once the desired temperature has been reached.
The water is then kept at the desired temperature until you remove the kettle from the base to pour
out water. If you leave the kettle on the base, it will automatically switch back to standby mode after
approximately 20 minutes.
Automatic shutoff
The device switches to standby mode shortly after the selected temperature is reached. The shutoff
time is extended if the pot is only filled with a little water.
The shutdown takes place automatically if the pot is lifted from the base.
For functional reasons, some condensation may run out of the outlet openings at the bottom of the
handle to the edge of the base. This happens for technical reasons and does not impair the safety of
the device.
Safety system
A thermostat protects the kettle from overheating due to accidental operation without water by
switching off the device.
It is essential to allow the pot to cool down before filling with water.
Should the first thermostat malfunction due to improper use, an additional temperature limiter
ensures reliable protection.
10
Advertenties
Inhoudsopgave
