Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Preparation
Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
If filling the tank from a water line, ensure that the line or a hose does not project
into the tank.
1. Pull up the red button on the safety valve [12] until all excess pressure is released from
the tank. (Fig. 5).
2. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 6).
3. Unscrew the pump [2] from the tank [1]. (Fig. 7).
+
To ensure the pump remains clean during storage, we recommend you attach the
pump to the pump holder [8]. (Fig. 8).
4. Add the liquid to the tank [1]. (Fig. 8)
5. Check the level [36] on the hose [4]. (Fig. 8a)
All excess pressure must be released from the device.
+
Move the transparent hose [4] on the tank [1] from top to bottom several times (the li-
quid level in the hose and tank is equalized). The liquid level [36] visible in the hose [4]
then corresponds to the level in the tank and can be read off the scale [35]. (Fig. 8a)
6. Screw the pump [2] into the tank [1]. (Fig. 9)
7. Swivel in the pump holder [8]. (Fig. 9)
8. Press the pump handle [13] down and turn it clockwise.
► The pump handle is unlocked. (Fig. 10)
9. Generate pressure (approx. 2 bar) in the tank [1] (Fig. 11).
+
The maximum pressure should not exceed 6 bar (red line on the pressure gauge
[16], Fig. 11). If the maximum pressure is exceeded, the safety valve will engage and
release the excess pressure.
10. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 6)
Use
Observe the instructions in the section entitled "Safety".
1. Connect the plug-in coupling [15] of the water pressure tank to the plug-in nipple [29] on
your device (Fig. 12)
2. Activate the ball valve [30]. (Fig. 12)
► The liquid starts to be supplied.
+
The amount of liquid can be regulated via the ball valve [30] on the device (e.g. drill).
3. If the pressure drops below 1 bar (min. 0.5 bar), pump again. (Fig. 11)
4. If the tank is empty, refill. (→ See chapter entitled „Preparation")
15
ENGLISH
Advertenties
Inhoudsopgave
