Inhoudsopgave
Advertenties
EN
SCOPE OF APPLICATION
1
Evolution 30 LTC-s is a battery-powered sprayer with electronic control that guarantees CONSTANT SPRAYING THROUGHOUT
THE ENTIRE TREATMENT and is equipped with two wheels for easy transport. Enables to easily select the most suitable
work mode for each type of application.
For that purpose, this model has two
positions. A high pressure (HP) position
suitable for insecticide and fungicide
treatments, where fine droplets with a good
coverage are required and another low
pressure (LP) position suitable for herbicidal
treatments with thicker droplets, which
eliminates drift.
The MATABI ACCESSORIES enables the operator to tailor the equipment to each type of treatment [1.b]. For more
information, see www.matabi.com.
This sprayer has been designed so as to apply phytosantiary products (fungicides, herbicides and insecticides) approved by
the authorities which regulate these types of products for use with sprayers. Under no circumstances whatsoever should the
apparatus be used for spraying flammable and industrial products (solvents, acids, alkalis, etc.).
It is important that this manual is read and understood prior to starting to use the equipment.
Pay special attention to equipment cleaning and maintenance tips so as to ensure an extended
service life of the sprayer.
Similarly pay special attention to safety regulations. Failure to follow the instructions and safety
warnings may result in serious injury.
may create the issues as described below.
2
ASSEMBLY AND START UP
• ASSEMBLY: For assembly follow the instructions given in the photos in Section [2.a].
• VERIFICATION: Verify with water that the equipment has been assembled correctly, that it is not damaged and is in good
working condition.
• START-UP: For starting up follow the instructions given in the photos in Section [2.b].
• BATTERY: Before each working day, ensure that the battery is charged. To charge the battery, see Section 6. Battery.
When installing the battery in the equipment, ensure that it is securely locked. [2.13]
• CHEMICAL PRODUCT: For difficult to dilute products, it is recommended to prepare the mixture beforehand in a separate
container.
• WORKING POSITION SELECTION: Select the nozzle and the most suitable working position for your application according
to Tables T.1 and T.2. [2.14]
EQUIPMENT PERFORMANCE MAY BE REDUCED IF A NOZZLE IS USED WHICH HAS NOT BEEN RECOMMENDED
IN TABLES T.1 AND T.2.
• TURNING THE EQUIPMENT OFF: The equipment is fitted with a pressure switch which stops the motor when the handle
is released, but the equipment is still turned on. To completely turn the equipment off, set the switch to the OFF position
according to the photo [2.16].
TO EXTEND THE EQUIPMENT'S SERVICE LIFE, AT THE END OF THE WORKING DAY, TURN THE MAIN SWITCH OFF,
ACTIVATE THE HANDLE TO RELEASE THE PRESSURE FROM THE HYDRAULIC CIRCUIT [2.15] AND REMOVE THE
BATTERY FROM THE EQUIPMENT.
The following symbol helps the operator to recognise the situations which when not followed
Droplet size: VC: Very thick; C: thick; M: medium; F: fine
VC
C
M
F
VC
C
M
F
Advertenties
Inhoudsopgave
