Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
• Do not use the pipe if the pipe is damaged.
If you want connect this machine to portable
water mains, you must install a backfl ow
preventer in the water pipe to prevent dirty
water fl ow back to the drinking water system.
The backfl ow preventer shall comply with
EN 60335-2-79 ANNEX AA.
2. MACHINE INFORMATION
Intended use
The high pressure cleaner PW505AC is quick and
effi cient for cleaning vehicles, machines, boats,
buildings, etc. Only clean vehicle engines in areas
in which suitable oil traps are installed.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Input power
Max. pressure water supply
Max. water temperature
Rated fl ow rate
Max. fl ow rate
Rated pressure
Max. pressure
Weight
IP class
Protective class
Lpa (sound pressure)
Lwa (sound power)
Max. LwA (sound power)
Vibration
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. High pressure cleaner
2. On/off switch
3. Water inlet fi lter
4. Hose holder
5. Water outlet
6. Gun holder
7. Handle
8. Cable holder
8
9. Spray gun
10. Adjustable spray lance
11. Turbo lance
12. High pressure hose
13. Cleaning needle
14. Detergent tank
3. ASSEMBLY
Assembly of the handle and hose holder (Fig. A, B1)
1. Assemble handle (7) and hose holder (4) as
2. Tighten the screws.
PW505AC
Assembly of the gun holder and cable holder
220-240 V~ 50/60Hz
(Fig. A, B2)
Assemble gun holder (6) and cable holder (8) as
1800 W
shown in Fig. B2.
12 bar
4. OPERATION
50 °C
6 l/min
7 l/min
100 bar
140 bar
8 kg
IPX5
II
74.6 dB(A) K=3dB(A)
88.3 dB(A) K=3dB(A)
90 dB(A)
2
2.089 m/s
Turning on (Fig. A, C)
1. Turn the switch (2) to the "OFF/0" position.
2. Ensure that you have a suitable water supply to
3. Connect lance (10 / 11) as shown in Fig. C1.
4. Connect the high pressure hose (12) to the
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
shown in Fig. B1.
The machine may cause electrical
disturbances when starting.
The motor of this pressure washer will NOT
run. It will only operate when the trigger is
squeezed.
The cleaner must only be used with clean
water; use of unfi ltered water or corrosive
chemicals will damage the cleaner.
If the motor stops and fails to restart, wait
2-3 minutes before restarting. THERMAL
CUTOUT TRIPPED.
feed the pressure washer.
washer as shown in Fig. C2 and connect the
spray gun (9) to the high pressure hose (12) as
shown in Fig. C3.
WWW.VONROC.COM
Advertenties
Inhoudsopgave
