Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Vario V Touch
Load Label Roll in Rewind Mode
NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be
damaged, the label material should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.
J
I
H
G
NOTICE!
In rewind mode the labels are wound up internally after printing for later use.
•
Open the printer cover.
•
Open the printhead (I) by turning the pressure lever (J) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
•
Lead the label material below the label guiding (D).
Pay attention that the label runs through the photocell (G).
•
Place the labels around the front sheet (H) and lead them below the mechanics to the rear.
•
Clamp the label material, with the handle (E) designated for it, at the rewinding roll (F).
•
In order to move the printhead (I) down, turn the pressure lever (J) in clockwise direction until it locks.
•
Adjust the limit stops (C) of the label guiding to the width of material.
•
Close the printer cover.
60
English
A
B
C
D
E
F
Advertenties
Hoofdstukken
Inhoudsopgave
