Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1
Display
2
SNOOZE / LIGHT
3
Time
4
Seconds
5
Radio tower indicator
6
Temperature indicator
7
Day of the week indicator
Date indicator, D=day,
8
M=month
9
Alarm 2 (6 - 7)
10
Alarm 1 (1 - 5)
11
Alarm time
12
Snooze indicator
13
12/24 hour time format
Setup
Remove the protective film from the display of the alarm clock. Open the battery
compartment 19 on the backside of the device and insert a 1.5V AA R6/LR6
battery in the correct polarity. Close the battery compartment 19.
Radio time signal reception starts automatically after inserting the
battery and the alarm clock will beep once. The radio tower indicator
blink on the display. This process can take 3-10 minutes.
Note: Please do not move the alarm clock during the reception process.
The alarm clock synchronizes the internal clock every day from 01:00 to 04:00
on each full hour. If reception is unsuccessful, the clock will reattempt reception
at 05:00 and 06:00. Please set the time manually, if reception fails (see "Basic
settings").
If reception is successful, the radio tower indicator
on the display and the time, date and day of the week are set automatically.
During daylight saving time, DST appears on the display next to the radio tower
indicator.
Time zone adjustment
If you are in a country in which the current time is incorrect even though the
DCF77 signal was received, please use the time zone adjustment to adjust the
time zone to a different setting than the standard setting (UTC+1 = Central
European Time). Set the difference in hours (for example -01) to the required
time zone.
Press and hold SET / °C / °F 14 for 3 seconds in normal time display mode.
The language of the day of the week will blink. Press SET / °C / °F 14 8x.
14
SET / °C / °F
15
ALARM / SET
16
RCC / RESET
17
/ ALARM ON / OFF
18
/ RCC OFF
19
Battery compartment
5 will
5 appears permanently
- 4 -
Advertenties
Hoofdstukken
Inhoudsopgave
