Download Inhoudsopgave Inhoud Print deze pagina

Trouble Shooting; Winter Storage - Swim & Fun 1087 Gebruikershandleiding

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 71
UK
Beware! Cleaning the bottom of the pool
This filter system cannot be used for the vacuuming of the pool floor. For this you will
need a pump with a motor power of at least 250W.
W can instead recommend the CleanRunner pool robot (art. 1046)
8.

Trouble shooting

Problem
At startup. The pump runs but
pumps no water
The pressure is too low
Leaking filter assembly (be-
tween lid and tank)
The pump is not running
The pump sucks air (bubbles
at the inlet)
Insufficient water supply to
the skimmer or pump
NOTE!
Repairs to the sand filter and pump may only be carried out by qualified, professional
firms, otherwise the warranty will lapse.
9.

Winter storage

When the summer season is over, disconnect all hoses. The water MUST be drained completely
from the filter. Remember also that the water must be drained from the pump through the inlet or
outlet before placing it in a dry, frost-free place. The pump and filter tank are not frost-proof. Frost
damage is not covered under the warranty.
58
Reason
There is air in the system.
The pump is not located at the
same level as the pool bottom.
The pump or hoses may be
blocked with leaves and the
like.
Worn or dirty gasket
The plug is not plugged into
the socket
The residual-current device
switches off
Faulty pump motor
Defective hoses
Loose hose clamps
The water level is too low
MV-1087-11-2021 . © Alle rettigheder forbeholdes Swim & Fun A/S
Trouble shooting
The pump must be lower so the water
always flows naturally towards the pump.
The hoses are primed (see the procedure
in paragraph 6)
Clear the inside of the top valve of dirt
and check for impurities, such as leaves
etc the hoses.
The gasket needs to be replaced with
a new gasket, or cleaned and acid-free
Vaseline applied.
Plug in
Turn the residual-current device on again
Turn it off immediately, either the pump
or the residual-current device is defective.
Replace the entire pump.
Replace the hoses
Tighten the hose clamps
Top up the water in the pool, so the water
line comes up to the pool edge

Advertenties

Inhoudsopgave
loading

Inhoudsopgave