Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1.
Press the dust container release button and rotate the container in the direction
indicated by the arrow in the diagram. This will allow the dust container to be
removed. To install it again, gently snap it into the body of the machine following
the arrow indicated and rotate it until you hear a clear "click". Make sure it's
properly secured. (IMAGE 11)
2.
Hold the handle of the HEPA filter and turn it counterclockwise to the unlocked
position. Then, pull upwards to separate the cyclone component from the dust
container component. (IMAGE 12)
3.
As shown in the figure, rotate the HEPA component in the direction indicated
and remove it for cleaning. (IMAGE 13)
4.
After cleaning or washing and drying (replace if necessary), reassemble the parts
in the reverse order of disassembly and the vacuum is ready to use again. (IMAGE
14 & 15)
CLEANING THE ELECTRIC TOOTHBRUSH
1.
Use your finger to move the brush release button in the direction of the
indicated arrow and remove the side cover of the brush, as shown in the
enlarged figure. (IMAGE 16)
2.
Pull one end of the brush out in the direction shown in the figure, and then
remove the brush from the compartment for cleaning.
3.
After cleaning or replacing the brush, reassemble and install it in the reverse
order of disassembly.
VACUUM STORAGE
Battery Recall
1.
Press the battery release button and remove the battery in the direction shown
in the figure. (IMAGE 17 A
2.
Place the battery in a plastic bag and store it in a dry place.
Machine Storage
If you won't be using the vacuum for a long period of time, remove the battery, pack
the machine, and store it in a cool, dry place. Avoid placing it in direct sunlight or in a
humid environment.
TROUBLESHOOTING
Before taking the vacuum cleaner in for repair, please check the following points:
FAILURE
The engine
does not
rotate
-
Battery release button)
POSSIBLE CAUSE
•
The battery is dead.
•
Metal tubes, floor brushes,
batteries, and handheld
vacuums are not
assembled in place
SOLUTION
•
Charge the vacuum.
•
Check if the parts and
handheld vacuum cleaner
are properly mounted in
place.
ENGLISH
Advertenties
Inhoudsopgave
