Download Inhoudsopgave Inhoud Print deze pagina

Battery Charging - Aiwa ZENKAISUI EVO 5 AVC-630 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 46
ACCESSORY CHANGE
The accessories of the vacuum cleaner can be changed very simply. There are two
accessories in total:
1.
2-in-1 Sofa Brush (IMAGE 5)
2.
2-in-1 Gasket Brush (IMAGE 6)
To change accessories:
1.
Gently press the release button on the current accessory. (IMAGE 1B)
2.
Remove the attachment without exerting excessive force.
3.
Attach the new fitting by pressing until it stops.
Remember not to apply too much force to avoid damaging the eyelashes or holding
plastics.

BATTERY CHARGING

When the vacuum cleaner's display shows that the battery power is less than or equal
to 20%, the machine's gear will automatically switch to the mode in which there is no
high gear. It is recommended that the user recharge the vacuum cleaner. (IMAGE 7)
During the state of charge, the display shows the percentage of electricity. The outer
circle will have a white line that will rotate clockwise
1.
Plug in the Charger: Plug the charger into a power outlet in any of the ways
described below (IMAGEN3).
Note:
Charge the battery before using the appliance for the first time. It is
recommended to charge the battery fully in the first three uses. It is
recommended that each charging time be up to 12 hours.
Afterwards, do not charge the battery for long periods to avoid damage. The
charging time of this model is about 6 hours.
2.
During Charging: The battery indicator will flash and the charge percentage
will increase. Once charging is complete, the indicator will turn off after 5
seconds.
3.
During Use: When the battery is less than 10% charged, the indicator will flash.
Recharge the battery with the appliance turned off.
CHARGING MODES (IMAGE 3)
There are three ways to connect and charge the battery:
1. Charging on the Wall Bracket (A)
Place the vacuum cleaner on its wall mount.
Connect the bracket to the electrical power.
2. Charging with the Battery in the Vacuum(B)
Leave the battery installed in the vacuum.
Connect the charger to the power supply.
3. Charging the Battery Alone(C)
Remove the battery from the vacuum.
Connect the charger directly to the battery and electrical power.
HANDLING THE PORTABLE VACUUM CLEANER
To operate the handheld vacuum cleaner and adjust the display: (IMAGE 8)
ENGLISH

Advertenties

Inhoudsopgave
loading

Inhoudsopgave