Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
W IRING CON N ECT IO N
Make the connection between the receiver wires and the fan motor wires following the color
indications. Make sure the connection is tight.
Take ground
L
N
RECE IV E R PL ACE ME NT
1
1. Insert the driver inside the motor body.
2. Hook the engine body onto the left hook of the body mount and route the wiring so it does
not get pinched.
3. Position the motor body so that the holes fit and then screw the 4 body bracket screws to
the motor body.
Note: Make sure that the motor body is perfectly installed to the ceiling.
B L ADE AS SE MB LY
Advice: Washers for the blade screws can be placed on each screw before installing the
blades.
1. Align the blade holes with the screw holes on the motor, and then tighten all the screws
Select the blade screws and attach the first blade, lining up the holes in the motor with
the holes in the blade. Screw the blade in so that it is secured but without tightening the
screws too much to be able to place the rest.
2. Repeat the previous step with the rest of the blades.
3. Once all the blades are in place, tighten the screws completely so that the blades are fully
secured.
L input (black)
Remote
control
receiver
Input N
(white)
2
Ground (green/yellow)
DC L motor (gray)
DC L motor (pink)
DC L motor (red)
3
E NGLI SH
11
Advertenties
Inhoudsopgave
