Inhoudsopgave
Advertenties
IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE
REFERENCE.
Safety and care notes
WARNING!
• Never leave the child unattended.
• Ensure that all the locking devices are engaged before use.
• To avoid injury ensure that the child is kept away when
unfolding and folding this product.
• Do not let the child play with this product.
• Always use the restraint system.
• Check that the pram body or seat unit or car seat
attachment devices are correctly engaged before use.
• This product is not suitable for running or skating.
•
Age and weight usage: from 0 months up to 15 kg.
•
We recommend using lowest reclined position for newborn babies.
•
This product may only be used by one child at the same time
•
The parking device shall be engaged when placing and removing the children
•
The maximum basket load is 3 kg.
•
Any additional load suspended from the buggy handles, backrest and sides will cause stability loss. We do not
recommend hanging any bags on the parent handle.
•
Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or
accessories.
•
Lift the front suspension when going up a curb or step.
•
Do not place the product near open flame or other heat sources.
•
Do not use with an additional platform.
I BUGGY COMPONENTS (FIG. 1)
A.
Frame with mounted seat, safety harness and canopy
B.
Front wheels x2
C.
Rear wheels x2
D.
Safety bar
II UNFOLDING BUGGY FRAME
Place the frame on a flat surface with its handle up (FIG. 2). In order to unfold the frame you must first move the slider,
press the lock button (both elements are located on the parent handle) (FIG. 3A) and lift the frame up until you hear the
locking sound (FIG. 3B). Note! To facilitate the unfolding of the frame, push the parent handle to the stroller frame in
such a way that all the elements fit tight. The lock mechanism is unlocked correctly.A properly unfolded frame is shown
in FIG. 4.
III WHEEL ASSEMBLY/DISASSEMBLY
Insert the rear wheels in the rear axle until you hear the locking sound (FIG. 5).
To remove the rear wheel, press the button on the rear axle (FIG. 6A) while pulling the wheel out of the slot (FIG. 6B).
Insert the front wheels in the slots at the front of the frame until you hear the locking sound (FIG. 7A).
To remove the front wheels, push the button located on the frame under each wheel (FIG. 7B).
NOTE! Before using the buggy, make sure that all the wheels are
properly installed.
IV CANOPY INSTALLATION
A brand new buggy comes with a partially mounted canopy. However, also fasten the Velcro fastener underneath the
backrest and the press studs on the sides of the shell (FIG. 8A and 8B). A correctly mounted canopy is shown in FIG. 9.
V ASSEMBLY/DISASSEMBLY OF THE SAFETY BAR
20
Advertenties
Inhoudsopgave
