Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TFA_No. 35.1133_Anleit_12_20
SUN - Wireless weather station
Changeover from summer time or winter time is automatic. In Daylight Saving Time "DST" is
shown on the LCD. The quality of the reception depends mainly on the geographic location.
Normally there should be no reception problems within a 1,500 km radius around Frankfurt.
Please take note of the following:
• The recommended distance to any interfering sources like computer monitors or TV sets
is at least 1.5 - 2 meters.
• Inside ferro-concrete rooms (basements, superstructures), the received signal is naturally
weakened. In extreme cases, please place the unit close to a window to improve the recep-
tion.
• During nighttime, the atmospheric interference is usually less severe and reception is pos-
sible in most cases. A single daily reception is adequate to keep the accuracy deviation
under 1 second.
4.2 Inserting the batteries in the base station
• Open the battery compartment of the base station.
• Insert two new batteries 1,5 V AAA. Make sure the polarities are correct.
• Close the battery compartment again.
• For a permanent backlight and to conserve battery power, use the supplied power adapter.
• The batteries will operate as a backup power source in case of power failure.
4.3 Backlight
• Attention: Continuous illuminated backlight only works when using the power adapter.
• Press LIGHT/SNZ button and you can select between four levels of brightness.
• To temporarily activate the backlight, press LIGHT/SNZ button (in battery operation only).
5. Operation
• Important: During the reception of the signal for the outdoor temperature and the time the
buttons will not function.
• During the operation, all successful settings will be confirmed by a brief beep tone.
22
27.12.2020
15:30 Uhr
Seite 12
SUN - Wireless weather station
• The instrument will automatically quit the setting mode if no button is pressed for a long
period of time.
• Press and hold ▲ or ▼ button in the setting mode for fast running.
5.1 Manual setting of the clock and calendar
• Press and hold the MODE button to get into the setting mode.
• The year indication (2014 default) will be flashing.
• Press the ▲ or ▼ button to adjust the year.
• Press the MODE button and the setting sequence is shown as follows: Month, day, date,
month/day sequence (American version) or day/month (European version), the language
for the weekday (GE - default), the time zone (00 - default), 12 (PM appears on the display
after 12 h) or 24 hours display (24 hr - default), hours and minutes. Press the ▲ or ▼
button to adjust them.
• The manually set time will be overwritten by the DCF time when the signal is received suc-
cessfully.
5.1.1 Setting of the time zone
• In the setting mode you can make the time zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF signal can be received but
the time zone is different from the German time (e.g. +1=one hour later).
• Press the ▲ or ▼ button.
• Confirm the setting with the button MODE.
5.1.2 Day-of-the week language
• Day-of-the week language: German (GE - default), French (FR), Italian (IT), Spanish (SP),
Dutch (DU), Danish (DA) and English (EN).
5.2 Setting of the alarm
• Press and hold the ALARM button.
• AL and 6:00 (default) appear on the display.
23
Advertenties
Inhoudsopgave
