Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
•
•
•
13 Troubleshooting
This chapter provides you with important notices with regard to operating
the device. Observe the following notices to avoid dangers and damages:
13.1 Safety notices
► Only qualified electricians, who have been trained by the
► Improperly performed repairs can cause considerable dangers for the
13.2 Fault indications
describes the cause of the fault.
Error code
E01
Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking chamber
temperature of 300°C. Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E03
Sensor fault
The device has detected an error on a sensor and has terminated the current
programme. Press the Stop button to acknowledge this fault.
► If error messages continue to appear after an extended waiting period
caso MCG 25 Chef (pure white, black)
Exterior housing
Clean the exterior surfaces of the device with a damp cloth.
Rotating plate, baking sheet and rolling ring
The glass turntable and baking sheet must be removed and cleaned
occasionally. Wash the plate in a warm soapy solution or in the
dishwasher.
The rolling ring should be cleaned regularly to prevent excessive noise
development or a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the
dishwasher. Please remember to put the rolling ring back again properly
after cleaning it.
Wipe the bottom of the oven with a mild cleaning agent. If the floor of
the oven is excessively dirty, you can use a mild cleaning agent.
Attention
manufacturer, may carry out any repairs on electrical equipment.
user and damages to the device.
In the event of a fault, an error code will appear in the display; it
Please note
and restarting the device, then the device will need to be sent to
Customer Service to be inspected.
Description
77
Advertenties
Inhoudsopgave
