Using And Selecting The Different Active Operating Modes; Switching The Led Strip On/Off - Zodiac iAquaLink CONTROL Z550iQ Gebruikshandleiding
Verberg thumbnails
Zie ook voor iAquaLink CONTROL Z550iQ:
- Installatie en gebruikshandleiding (28 pagina's) ,
- Snelstartgids (185 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.4.4 Using and selecting the different active operating modes
In "Heating" mode, the heat pump has 3 active operating modes for adjusting its operating speed to the power that is
required and the mode that is selected.
Depending on the selected operating mode ("BOOST", "SMART" or "ECOSILENCE"), the power delivered by the heat
pump can vary over a predefined range (depending on the speed of its compressor and fan).
The number of lit LEDs on the strip reflects the compressor's actual operating speed. This feature is particularly useful
in the "SMART" and "ECOSILENCE" modes to see if the machine is operating at its maximum over the predefined power
range or, on the contrary, at a reduced power level.
HIGH
100%
MID
75%
LOW
50%
The LED strip goes up to "HIGH"
Status
Quickly increasing the setpoint
Objective
temperature
When to use
When commissioning the pool
* The compressor speed directly affects the appliance's power output.
To select the active operating mode:
• From the main screen (where the measured water temperature is displayed), press
front of one of the 3 operating modes ("BOOST", "SMART" or "ECOSILENCE").
• Press
until reaching the desired mode. Once the indicator
it is confirmed automatically.
2.4.5 Switching the LED strip on/off
The front LED strip is lit by default. To switch it off:
• From the main screen (where the measured water temperature is displayed), press and hold
«COOL» is displayed on the screen.
• Press
and release. «LED» is displayed on the screen.
• Press
and release. «ON» is displayed on the screen.
• Press
and release: «ON» flashes.
• Press
and release: «OFF» flashes.
• Press
and release.
The LED strip is switched off and the LEDs will remain unlit.
Active operating mode
BOOST
The LED strip fluctuates
between "LOW", "MID" and
Intelligently controlling the
To avoid having to intervene on
SMART
"HIGH"
Heating
operating speed
Automatically adapting the power to requirements
To maintain the temperature
To benefit from quiet operation
the appliance
when little heating is required
is placed in front of the desired operating mode,
ECOSILENCE
The LED strip fluctuates
between "LOW" and "MID"
Operating the most
economically and quietly
. The indicator
stops in
.
EN
17
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
