Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Option 33 - Enable On at upper limit
This enables an ON function to be selected if a set
point above the upper limit is selected. Press + until
Option 33 is displayed, use
setting.
Setting 0 Disabled (factory setting)
Setting 1 Enabled
Option 34 - Select on/o or chrono-proportional cycle rate
This allows the thermostat to be set to run in on/o
mode or for a chrono-proportional cycle rate to be
selected. Press + until Option 34 is displayed, use V
and Λ to select required setting.
On/O
0
3 cycles per hour
3
6 cycles per hour (factory setting)
6
9 cycles per hour
9
12 cycles per hour
12
Option 35 - Set integration time (seek advice prior to adjusting)
(Option 34 set to 3, 6, 9 or 12)
This adjusts the integration time of the PI
algorithm to increase control accuracy. It should
only be adjusted after seeking advice from the
manufacturer. Press + until Option 35 is displayed,
V
Λ
use
and
to select required setting.
Integration time set to 2.5% (factory setting)
2.5
Integration time set to 5%
5
Integration time set to 10%
10
Option 36 - Set temperature override rule
This establishes the degree of temperature override
available to the user. Press + until Option 36 is
V
displayed, use
Setting 0 No limit (factory setting)
Setting 1 Limited to ±2°C
Setting 2 No override allowed
V
Λ
and
Λ
and
to select required setting.
to select required
GB
7
Advertenties
Inhoudsopgave
