Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
10.6 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! If possible keep always drain
WARNING!
▶ Use only the supplied hose set for the connection.
▶ Never reuse old hose sets!
▶ Only connect to cold water supply.
▶ Before connection, check whether the water is clean and clear.
Following connections are possible:
10.6.1 Drain hose to sink
Hang the drain hose with the U-support over the
▶
edge of a sink with adequate size (Fig. 10-8).
▶
ping.
10.6.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
▶
vent-hole must be minimum 40 mm.
Put the drain hose for 80-100 mm in the
▶
wastewater pipe.
▶
(Fig. 10-9).
10.6.3 Drain hose to sink connection
The junction must lie above the siphon.
▶
A spigot connection is usually closed by a pad (A).
▶
That must be removed to prevent any disfunc-
tion (Fig. 10-10).
Secure the drain hose with a clamp.
▶
CAUTION!
▶ The drain hose should not be submerged in water and should be securely xed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being lled (self-si-
phoning).
▶ Drain hose is not to be extended. If necessary contact after sales service.
10-Installation
10-8
-
10-9
10-10
27
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
