Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note on parallel connection:
Several sensors can be connected
in a DALI-2 system. In this case,
the maximum number of DALI users
must not be exceeded
(➜ "12� Technical specifications")
5� Mounting
• Check all components for
damage.
• Do not use the product if it is
damaged.
• Select an appropriate mounting
location, taking the reach and mo-
tion detection into consideration.
(Fig� 5�1 / 5�2)
Mounting procedure
• Switch off power supply (Fig� 4�1)
• Detach decorative trim panel from
frame. (Fig� 5�3)
• Fit mounting box Ø max. 68 mm
into the ceiling cut-out. (Fig� 5�4)
• Connect to the mains power
supply. (Fig� 5�5)
• Fit sensor module and screw into
place. (Fig� 5�6)
• Fit decorative trim panel. (Fig� 6�3)
• Switch ON power supply.
(Fig� 6�3)
• Make settings.
(➜ "7� Function / operation")
6� Changing the detection
zone
Detection zone (Fig� 6�1 / 6�2)
The film shroud provided is used
for minimising the detection zone
by a maximum of 40 %.
7� Function / operation
Once you have connected the unit
and fitted the designer panel, you
are ready to put the system into
operation.
The sensor is put into operation
in accordance with the applicable
DALI-2 standard. All functions and
commands are available from DALI
standard IEC 62386 Part 101,
Part 103, Part 303 and Part 304. The
motion detection values and light
levels measured by the sensor can be
requested from the DALI Application
Controller. Automatic or time-based
cyclical transmission can also be
selected.
You will find detailed information
in the interface description on the
Internet at: DALI-2.steinel.de
LED function:
Red LED
Initialisation: LED flashes once every
2 seconds
Normal mode: LED stays OFF.
DALI identification: LED flashes once
a second.
8� Accessories
– Kaiser hollow-wall box
EAN 4007841000370
9� Care / maintenance
The product requires no mainte-
nance.
The detector lens may be cleaned
with a damp cloth if it gets dirty (do
not use cleaning agents).
- 18 -
Advertenties
Inhoudsopgave
