Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
1� About this document
Please read carefully and keep in a
safe place�
– Under copyright. Reproduction
either in whole or in part only with
our consent.
– Subject to change in the interest
of technical progress.
Symbols
!
Hazard warning!
Reference to other
...
information in the document�
2� General safety
precautions
Disconnect the power
!
supply before attempting
any work on the unit�
• During installation, the electric
power cable to be connected
must not be live. Therefore, switch
off the power first and use a volt-
age tester to make sure the wiring
is off-circuit.
• Installing the sensor involves work
on the mains power supply. This
work must therefore be carried
out correctly in accordance with
applicable national wiring regu-
lations and electrical operating
conditions. (e.g.: DE: VDE 0100,
AT: OVE-EN 1, CH: SEV 1000)
• Only use genuine replacement parts.
• Repairs may only be made by
specialist workshops.
3� IR Quattro SLIM XS
Proper use
– Presence detector only suitable
for mounting on indoor ceilings.
– A device box with a depth of at
least 57 mm is required.
The sensor is connected to the
control unit via a DALI bus.
The sensor uses the DALI line for
communication and for supplying
power.
Package contents (Fig� 3�1)
Product dimensions (Fig� 3�2)
Product components (Fig� 3�3)
A
Sensor module
B
Decorative trim panel
C
Sensor lens
D
Connecting terminal
4� Electrical connection
• Switch OFF power supply.
(Fig� 4�1)
Wiring up the sensor switch: under
section 6 of VDE 0100520, a mul-
ti-core lead containing both the mains
voltage leads as well as the control
leads (e.g. NYM 5 × 1.5 mm²) may be
used for the wiring between sensor
and DALI Application Controller.
The lead between DALI Application
Controller and sensor must be no
longer than 300 m (with 1.5 mm²).
After installing and switching ON,
the sensor flashes for 40 seconds.
Connecting the mains power supply
lead (Fig� 4�1)
- 17 -
GB
Advertenties
Inhoudsopgave
