Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Positioning model 1262-S with a spacer
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180°
(see Fig. H).
Loosen the spacer star knob
„ „
the height of the floodlight (see Fig. H).
When the desired position is obtained,
„ „
tighten the star knob again.
Loosen the Spotlight star knob
„ „
the angle (see Fig. H).
When the desired position is obtained,
„ „
tighten the star knob again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob (due to the design,
we recommend using an offset screwdriver).
Please note: the motion sensor has a field
of view of up to 120°. Make sure that the
motion sensor faces directly towards the
desired detection zone.
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
is not dirty.
z Charging the battery
The battery is charged in all operating
„ „
modes. To optimise initial charging, charge
the product while it is turned off.
Please note: the battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours. The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight.
z Operation
The product can be operated in three
different modes. The operating mode is set
by means of the switch
Please note: the solar panel will turn on the
product in twilight or darkness in the mode
you have set.
Please note: battery charging via the solar
50
GB/IE/NI/CY/MT
to adjust
10
to adjust
6
2
�
5
panel does not depend on which mode is
selected. The battery is charged continuously
at all times.
Mode 1
Press and hold the switch
„ „
to switch to "Mode 1".
The floodlight will light up once and remain
„ „
lit at low brightness.
If the motion sensor detects movement
„ „
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, the floodlight
„ „
will light up again at low brightness.
Mode 2
Press the switch
„ „
5
"Mode 2".
The light will flicker twice and then switch
„ „
off.
If the motion sensor detects movement
„ „
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, it will switch off
„ „
again.
Mode 3
Press the switch
„ „
5
"Mode 3".
The light will flicker 3 times. The floodlight
„ „
will light up with low brightness. The motion
sensor is inactive in this mode.
Switching off the Spotlight
To switch off the Spotlight, press the switch
„ „
for a fourth time.
5
for 3 seconds
5
again to switch to
again to switch to
Advertenties
Inhoudsopgave
