Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
After Use:
1. Turn off control valve (8.1) (tighten clockwise) to extinguish flame. 2. Remove pot from
burner base – hold pot by cozy (10.1), and base by shroud (10.2).
Exposed metal parts will be hot and may cause injury if touched.
WARNING
3. Always disconnect fuel canister after use. Unscrew fuel canister from burner base (Fig
4), and replace plastic fuel cap.
Always check that the burner is extinguished before disconnecting the fuel
WARNING
canister. Vapors can ignite and cause serious injury.
Packing:
1. Allow stove to fully cool before packing. 2. Place bottom cover (7.1) on pot (7.2).
3. Remove stabilizer from canister and fold for storage (1.2). 4. Fold Valve bail under valve
body (1.3). 5. If using the pot support: Remove pot support from burner base (Fig 12), and
fold legs (1.4). 6. Refer to Fig 1 for packing contents into pot.
Storage After Use:
1. Always disconnect fuel canister before storing the stove. 2. Ensure stove and pot are
clean and dry before storing. 3. Store the stove in a cool, dry location, indoors.
Maintenance:
1. Flame Check (Every use): The height of the flame should increase from low to high with
counter-clockwise rotation of the control valve. Flame should be blue with no yellow tipping
at full output. Flame should not flash back into burner or lift off of burner top. If flame
abnormalities are found, see your dealer or contact Jetboil for service. 2. Cleaning Pot
(before storage, or as needed): Allow pot to cool before cleaning. Do not use a dishwasher
or abrasive compounds (sand, salt, etc.) to clean. Only wash by hand with soapy water.
Troubleshooting:
1. Flame does not extinguish: Tighten valve as much as possible, blow out flame, and
immediately detach fuel source. See your dealer or contact Jetboil for service. 2. Igniter
fails to spark: If igniter will not spark, check positioning of electrode in relation to burner.
Approximately 1/8" (3mm) length of igniter wire should protrude from the igniter ceramic.
Wire should point toward center of burner with a 1/8" (3mm) gap between the end of
the wire and the top surface of the burner. If not positioned as described, re-position the
electrode accordingly. Bend wire towards center of burner head and position as described
above. If stove is wet, igniter may fail to spark. If igniter fails to spark, use matches or
a lighter, following instructions detailed in OPERATING INSTRUCTIONS – Lighting the
Burners. See your dealer or contact Jetboil for service if igniter fails to spark for any
other reason. 3. If an issue cannot be corrected using these instructions, see Limited
Warranty on back page.
8
Advertenties
Hoofdstukken
Inhoudsopgave
