Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATING INSTRUC
• Keep burner at arm's length, away from face, during ignition. Flame can flare during
ignition.
• Do not attempt to light with included pot or any other cookware on the burner. Gas
build-up can occur, resulting in increased flame eruption.
• Never expose stove to flammable vapors or liquids while lighting the burner. It can
cause an explosion or fire.
• Do not heat empty pot. Product will melt and potentially catch fire.
• Do not move, lift, or tilt stove with lit burner. Product damage or injury can occur due
to flaring.
• Do not fill pot more than half full. This may cause boil-over, resulting in injury.
• If attempting to heat anything other than water, use care and stir frequently to avoid
boil over or scorching, which may result in product damage or injury.
• Always check that the burner is extinguished before disconnecting the fuel canister.
• Do not use for boiling oil or deep frying. Product damage or injury can occur due to
overheating.
Preparation:
1. Remove bottom cover (7.1) from bottom of the Jetboil pot (7.1). 2. Remove Pack Bag
(if included). 3. Remove Pot Support Warning Tag. 4. Add contents to the pot, cover with
lid, but do not put the pot on the stove yet. Now you are ready to light the burner. 5. Test
igniter by depressing igniter button (8.2) until click is heard. If it does not spark, refer to
Maintenance and Troubleshooting sections.
Performance may be suboptimal if used in extreme conditions (cold, hot, wind, altitude).
NOTICE
Do not use stove to warm fuel canister. Can result in explosion.
WARNING
Lighting the Burner:
Ensure burner base is free of any pot prior to lighting. Gas build-up can occur,
CAUTION
resulting in increased flame eruption.
1. Open control valve (8.1) counterclockwise until fully opened and gas flow can be heard.
2. To light, depress Igniter Button (8.2) until click is heard. Repeat as necessary until
ignition (Fig 9). 3. If ignition does not occur within 5 seconds, close control valves and wait 5
minutes before repeating the procedure.
Usage:
1. If necessary, rotate control valve (8.1) clockwise to decrease flame setting.
2. Once the burner is lit, carefully place the pot with its contents on the burner base (Fig
10); turn as shown in Fig 11 to lock into place.
Use care when removing lid. Steam and/or contents may be hot and can
CAUTION
7
cause injury.
WARNING
Advertenties
Hoofdstukken
Inhoudsopgave
