Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason, always
wear protective gloves for changing the tool.
The work spindle of the machine has an M 14-internal thread. Keep threads and
front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Tool Protection
Wrong handling can cause damages on the tool. Therefore, the following
instructions should be observed:
Only use stirring rods which have a M 14-external thread
(diameter 120/140 mm max.) and are recommended by the producer.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Speed Selection
The MXT 100/2 is equipped with a mechanical two-speed gearbox. Select the
required speed by pressing-in, shifting and engaging. The position of the lower
speed is in direction of the working spindle. Change the speed only when the
machine is not running, and support the speed-changing by slightly rotating the
work spindle.
Switching on and off
To start the power tool, first press the lock-off button, then press the on/off switch
and keep it pressed.
Note: For safety reasons, the on/off switch cannot be locked; it must remain
pressed during the entire operation.
To switch off the power tool, release the on/off switch.
The Stirrer is equipped with an electronic switch. With this switch the speed can be
regulated according to the pressure on the button. Only use the electronic switch
when you want to start or stop the machine in order to avoid material splashing
around. A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be overheated much
faster.
12
Advertenties
Inhoudsopgave
