Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not use the tool near explosive materials (petrol, dilution).
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only repaired
by specialists. Only insert the plug into the socket when the tool switch is off.
When the machine runs outside, always use a protection switch (30 mA max.)
against fault current.
The machine should only work under supervision of somebody. Plug and switch
the machine off if it is not under supervision, e. g. in case of putting up and
stripping down the machine, in case of setting up and striking, voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you avoid that
it starts suddenly and not under supervision.
Do not use the machine if one part of the housing is damaged or in case of
damages on the switch, cable or plug.
Electric tools have to be inspected by a specialist in regular intervals.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
Before starting up, check that the mixing rod is securely attached and rotates
without a hitch.
Do not reach into the mixing container with your hands or insert any other
objects into it while mixing is in progress. Risk of crushing!
Wait until the machine or tool comes to a complete standstill. Rotating tools
can snag and cause injuries or damage.
When working with this machine wear ear protectors, goggles protective
gloves and protective boots.
During use, always hold the machine with both hands and maintain a
safe standing position. Start up and run down the machine in the mixing
container only. Pay attention to the reaction moment of the machine.
For further safety instructions, please refer to the enclosure.
Electrical Connection
Before starting the machine, please check the correspondence between voltage
and frequency against the data mentioned on the identification plate. Voltage
differences of +6 % and -10 % are allowed. The Stirrer is made in protection class
II. Only use extension cables with a sufficient cross section. A cross section which
is too small could cause a considerable drop in performance and an overheating of
machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Cross section in sq. mm
1.5
20 m
50 m
11
2.5
40 m
80 m
Advertenties
Inhoudsopgave
