Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TFA_No. 30.5046_Anl_11_22
Digital Thermo-Hygrometer
Comfort level
Too Wet
Wet
Comfort
Dry
Too Dry
8.5 Alarm function when danger of mold
• If the humidity rises above 65%,
and a red warning light flashes.
• Press any button to stop the signal light.
•
stay on the display, until the measured
humidity is below the set value.
To change the alarm limit of 65%, please note the following
steps:
• Press and hold the °C/°F / ▼ button, until
and the humidity value flash.
• Press the ▼ or ▲ button to set the desired alarm limit (60, 65,
70 or 75% rH).
• Press and hold °C/°F / ▼ button for 3 seconds to confirm the
setting.
8.6 Set humidity alarm
• Press and hold the DEW POINT / ALERT SET button, until
appears.
• The humidity value and
• Press the ▼ or ▲ button to set the desired upper limit in steps
of 5 %.
• Press the DEW POINT / ALERT SET button again.
• The humidity value and
• Press the ▼ or ▲ button to set the desired lower limit in steps
of 5 %.
20
14.11.2022
10:08 Uhr
Relative humidity
81...90 %
61...80 %
41...60 %
31...40 %
20...30 %
appears
flash.
flash.
Seite 11
Digital Thermo-Hygrometer
• Confirm with the DEW POINT / ALERT SET button.
• Press the ALERT ON OFF button in normal mode to activate the
alert function.
•
appear on the display.
• In case of an alert,
the red LED signal light will be flashing.
• Press any button to stop the signal light.
•
and the symbol will continue flashing until the mea-
sured humidity is within the alarm limits.
• Press ALERT ON OFF button to stop the alarm.
9. Positioning and mounting of the device
• The device can be placed onto any flat surface with its fold out
stand (45°) or wall mounted with the mounting hole, both found on
the back of the unit.
10. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or
scouring agents.
• Remove the batteries if the device will not be used for an
extended period of time.
• Keep the device in a dry place.
10.1 Battery replacement
• Change the batteries when the battery symbol appears on the
display.
11. Troubleshooting
Problem
Solution
➜ Ensure the batteries' polarity are correct
No display
➜ Change the batteries
and the corresponding symbol and
21
Advertenties
Inhoudsopgave
