Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MW-5459600-Bedien-1807_(98) 18.07.18 09:44 Seite 60
5 – First Use
Checking the tacker and package
contents.
1. Remove the tacker from the
packaging.
2. Place the tacker on a flat and
stable surface, e.g. a workbench.
3. Check that the contents are
complete (see illustrations 1, 2
and 3).
4. Check for any apparent damage
to the tacker or the individual
parts. Should this be the case,
do not use the tacker. Contact
the manufacturer's service
centre indicated on the warranty
card.
6 – Operation
Charging the battery
• The battery should be delivered
partially charged. Charge the
battery before initial use for at
least 3 hours.
• If the battery charge indicator
light (1) turns red during
operation, the battery charge is
less than 30% and should be
recharged.
1. Insert the power plug of the
charging cable (11) into a
properly installed power outlet.
60
All manuals and user guides at all-guides.com
2. Plug the charging cable into the
micro USB charging socket (8).
The battery charge indicator LED
shows red.
3. As soon as the LED of the
battery charge indicator glows
green, the battery is charged.
You can unplug the charging
cable from the micro USB
charging socket.
Filling the staple magazine
At the level indicator (6)
you can see if there
are still staples (7b) or
nails (7a) in the staple magazine (9).
1. Make sure that the tacker is
switched off and that the on / off
switch (4) is in the "O" position.
2. Squeeze the staple magazine
lock (5) and pull the staple
magazine out to the rear.
3. Place the staples or nails
into the staple magazine (see
illustration 2).
4. Push the staple magazine latch
back into the stapler until the
staple magazine snaps into
place.
Switching the tacker on/off
− Set the on / off switch (4) to
position "I" to switch on the
tacker.
− Set the power switch to the "O"
position to turn off the tacker.
Advertenties
Hoofdstukken
Inhoudsopgave
