Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating mode
Standby
(by pressing the B button on
the receiver)
Standby
Comfort
Reduced
Frost protection
Boost
Sensor default or
measured T°C > 35°C
(*) Sensor =EXT => control via the sensor on the receiver installed on the towel radiator
Probe=INT => control via the transmitter sensor
The IR receiver has a self regulating system that memoris-
es status (on/off) information and temperature settings.
If the transmitter is off, or if the batteries are dead:
• with the 'Sensor'=Ext setting, the last order received is
used for regulation, even when the transmitter is off or
if the batteries are dead.
• with the 'Sensor'=Int setting, the receiver will shut off
automatically after 30 minutes maximum.
IMPORTANT: if your receiver is off, your towel radiator
will not receive orders from the IR transmitter with dig-
ital display. Your installation could freeze because the
device is unable to regulate.
Installing the IR transmitter with
digital display
• Install the IR transmitter with digital display in the
same room as the towel radiator. The transmitter
must be installed about 1.5 meters from the floor on
an interior wall, away from splashing water, direct
sunlight and any disturbance from direct heat such as
lamps, television sets, heating pipes, air flows, etc.
Note: To ensure perfect IR transmission:
• do not allow objects to come between the transmit-
ters and receivers (such as bath towels and bath
sheets).
• avoid using lamps with built-in electronic ballast in
the same room.
2
«A»/»F» LED status
radiator paused
Off
Solid green
Solid green
Solid green
Solid green
-
Flashing green/red
Infrared Thermostat Transmitter with Digital Display - Instructions PPLIMP10314/Bd of 03/03/2011
«A»/»F» LED status
radiator is heating
«Sensor = EXT» (*)
-
-
Solid red
Solid red
Solid red
Flashing red
-
Assembly instructions
1.50M
Min 20cm
• Remove the battery protection tabs:
Press the clip on the bottom of the transmitter and
pull the front panel to remove.
• The first step consists of choosing the language with
t u, then press OK.
LANG : Choose the language (FrANçais/English)
• Next, choose Turbo control, if any t
OK:
TURbO: Is the device equipped with a Turbo? (yes/no)
• The third step consists of setting the time
(while display is blinking).
• Using the + and - keys: Set the hours
then press OK.
• Next, using the + and - keys, set the minutes
then press OK.
• Next, using the + and - keys, set the minutes
then press OK.
(1 = Monday, 2 = Tuesday, 3 etc.)
• Next, using the + and - keys: set the day and month
then press OK.
«A»/»F» LED status
radiator is heating
«Sensor = INT» (*)
-
-
Flashing red
Flashing red
Flashing red
Flashing red
-
u
then press
Advertenties
Inhoudsopgave
