Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
d. Chase
1) Setting Channel Chase
1. Press the Function key (#7), press the ▼ key (#15) twice ("CHANNEL CHASE..." selected) and enter:
CH CHASE
MAS.=100%
2. Use the numeric keypad (#11) or the ▲/▼keys (#15 & 16) to set the start channel ; a range of 6 successive
channels is automatically selected. Press Enter (#14) ; the cursor will move to the time setting.
CH CHASE
MAS.=100%
3. Press the ▲/▼ keys (#15 & 16) to select the speed (21 possibilities between 0.1sec and 1min).
4. Set the channel faders (#2) to the desired level and the chase will automatically run the selected channels.
5. To modify channel range or chase time during a chase, press Enter (#14) and repeat the steps above.
6. The chase can also be music-controlled: connect an audio signal to the audio connector at the back (#21) ; the
device will now react to the beat of the music.
2) Setting Chase + Scene
1. After setting a chase, press the SC key (#5) to call out a scene ; the LCD will display
LOAD
SCENE
KEYIN SC 1...40
2. Use the numeric keypad (#11) to enter a scene number and press Enter (#14) to confirm. The LCD returns to:
CH CHASE
MAS.=100%
• If the scene value of a channel differs from the value defined by the fader, the higher one will be selected.
• Press any "SUB" key (#3) to send out the corresponding channel at 100%.
• Upon exiting chase mode, the selected chase speed will be memorized automatically.
3) Setting Chase Fade
1. Press the Function key (#7), press the ▼ key (#15) 5 times ("CHASE FADE..." selected) and enter:
→
FADE
FADE
2. Press the ▼ key (#15) to select "FADE ON" and press Enter (#14):
CH CHASE
MAS.=100%
3. Set the channel faders (#2) to the desired level and the chase will automatically run in fade mode.
4) Setting Sub Chase
1. Press the Function key (#7), press the ▼ key (#15) 3 times ("SUB CHASE..." selected) and enter:
→
CHASE
CHASE
2. Press the ▼ key (#15) to select "CHASE 3-6" and press Enter (#14):
SUB
CHASE
MAS.=100%
3. Press the ▲/▼ keys (#15 & 16) to adjust the chase speed and set the CH3-CH6 faders (#2) to the desired level
to control the chase ; the CH1-CH2 faders control the dimming of the selected scene.
4. To return to full chase mode, repeat steps 1 and 2 but select "CHASE 1-6" in step 2.
LPTJUNIOR
1-
6
9sec
1-
6
9sec
_
1-
6
9sec
OFF
ON
1-
6
9sec
1-6
3-6
3-6
9sec
5
VELLEMAN
Advertenties
Inhoudsopgave
