Advertenties
Beschikbare talen
Beschikbare talen
Using the inverter
6.2
Connecting the PP152 and PP154
!
WARNING!
The rating of the vehicle socket, the supply cable, and the fuse must be
at least 15 amps. Do not put in a fuse with a higher rating.
A
NOTICE!
Make sure that the plug is firmly connected in the vehicle socket. If the
connection is loose, the plug may heat up.
The connection is made via a plug that is connected to a 12 V vehicle socket (for
PP152) and a 24 V vehicle socket (for PP154). The middle pin of the plug (fig. 1 4,
page 3) must be connected to the positive wire and the two side brackets of the plug
(fig. 1 5, page 3) must be connected to the negative wire.
6.3
Connecting the PP402, PP404, PP602 and PP604
!
WARNING!
Do not reverse the polarity. Reversing the polarity of the connections will
cause a great spark and the internal fuses will melt.
➤ To set up the inverter, connect the red cable (fig. 1 4, page 3) to the positive
pole (+) of the battery and the black cable (fig. 1 5, page 3) to the negative
pole (–) of the battery. Make sure the vehicle battery terminals are clean when
connecting them.
7
Using the inverter
The main switch (fig. 2 1, page 4) on the back of the device has three positions:
• ON: the inverter is switched on.
• OFF: the inverter is switched off.
• REMOTE: the inverter is switched on and off by an external switch.
➤ Connect your power consuming device, to the socket (fig. 1 1, page 3) of the
inverter.
Switching on at the device
➤ Set the main switch (fig. 2 1, page 4) to "ON".
✓ The green LED (fig. 1 3, page 3) lights up.
12
PerfectPower
EN
Advertenties
