Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
2. Mark the locations of the two drilled holes, horizontally
next to each other and 60 mm apart.
3. Use a 5-mm drill bit to drill holes at the marked locations
(drilling depth: 40 mm).
4. Push the wall plugs provided into the drilled holes.
5. If necessary, align the adapter plate to the thickness of the
switch frame (only if you are not using the rotary button
frame included in the delivery).
6. Attach the adapter plate to the wall using the screws
provided.
7. Tighten the screws hand-tight using a Phillips screwdriver.
> The adapter plate is now attached to the wall.
4.2 Attaching the rotary button frame
and rotary button plate
Illustrated instructions
Instead of the rotary button frame included in the delivery, you
can also install the rotary button in a third-party switch frame
with an inside diameter of 55 mm.
1. Place the rotary button frame on the adapter plate.
2. Insert the rotary button plate into the rotary button frame
and press it.
> The rotary button frame and rotary button plate are
now attached.
» "II" on page 3
EN
17
Advertenties
