Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Replacing the batteries (Fig. E-2)
The console is equipped with 1 AA batteries at
the rear of the console.
- Remove the console.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
- Mount the console.
Console (Fig. E-1)
⚠ WARNING
•
Keep the console away from direct sunlight.
•
Dry the surface of the console when it is
covered with drops of sweat.
•
Do not lean on the console.
•
Only touch the display with the tip of your
finger. Make sure that your nails or sharp
objects do not touch the display.
‼ NOTE
•
The console switches to standby mode when
the equipment is not used for 4 minutes.
Explanation Display functions
RPM
- Display the rotations per minute.
- Range: 0 ~ 999 RPM.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
Time
- Automatically accumulates workout time when
exercising.
- Display range: 00:00 ~ 99:59.
Speed
- Displays current training speed.
- Range 0.0 ~ 99.9 / Units: KM/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0".
Distance
- Automatically accumulates the distance from
exercise when exercising.
- Range 0.0 ~ 999.9 / Units: KM.
Calories
- Automatically accumulates calories burnt when
exercising.
- Range: 0 ~ 9999 / Units: K.Cal.
‼ NOTE
•
This data is a rough guide for comparison of
different exercise sessions which cannot be
used in medical treatment
Explanation of buttons
Mode/ Reset
- Press Mode/ Reset button to select console
functions.
- Push and hold for 3 seconds in, stop Mode/
Reset, to reset: Time, Distance, Calories.
Opperation
Power on
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training data
will be lost )
Cleaning and maintenance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
•
Do not use solvents to clean the equipment.
•
Clean the equipment with a soft, absorbent
cloth after each use.
•
Regularly check that all screws and nuts
are tight.
•
If necessary, lubricate the joints.
English
15
Advertenties
Hoofdstukken
Inhoudsopgave
