FCC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1 - THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
2 - THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
MODEL: C3. FCC ID: 2AGNC-C3. IC 20967-C3.
FCC WARNING
Any Changes or modifications not ex-
pressly approved by the party responsible
for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the
FCC Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interfer-
ence received, including
interference that may cause undesired
operation.
This equipment complies with FCC
radiation exposure limits set forth for
an uncontrolled environment.Note: This
equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
IC
This device complies with Industry
Canada licence-exempt RSS stand-
ard(s). Operation is subject to the
following two conditions: (1) This
device may not cause interference,
and (2) This device must accept
any interference, including inter-
ference that may cause undesired
operation of the device.
harmful interference in a residential
installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different
Le présent appareil est conforme
aux CNR d'Industrie Canada
applicables aux appareils radio
exempts de licence. L'exploitation
est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire
de brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélec-
trique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.