Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION | INSTALLATION
CLEANING, CARE AND MAINTENANCE
5.
Cleaning, care and maintenance
Clean the taps with a damp cloth. Never use abrasive or corrosive
cleaning agents.
Descale the jet controller if it is clogged with limescale. Remove
it from the pivoting arm to do this.
6.
What to do if...
6.1
... there is no hot water
The mixer tap is fully opened. In this case it could be that the water
heater has not heated the water because there is no power. Check
the MCB/fuse and residual current device in your fuse box.
6.2
... the water fl ow rate is weak
It could be that the jet controller in the tap is contaminated or
scaled up. In this case clean the jet controller or descale it. You
can order the jet controller from us as a replacement part with
part number 279932.
6.3
... the shower is performing poorly
In this situation it could be that the hand shower is scaled up or
contaminated. If so clean the hand shower or descale it. You can
order the hand shower from us as a replacement part with part
number 279482.
6.4
... water is dripping from the tap
When water expands in the water heater, expansion water drips
from the tap. This is a normal process.
7.
Safety
7.1
Country-specifi c safety information
All required steps up to and including the commissioning must be
carried out by a qualifi ed contractor. During this process, these
installation instructions must be observed.
We guarantee trouble-free function and operational reliability
only if original accessories and spare parts intended for these
tap are used.
7.2
Instructions, standards and regulations
Observe all applicable national and regional regulations
!
and instructions. In Germany, for example, DIN 1988
and EN 806.
8.
Appliance description
8.1
Standard delivery
The standard delivery is shown in the following diagram. The MEB
tap is shown here as an example.
www.stiebel-eltron.com
8
1 Water inlet pipe (chrome-plated brass)
2 Wall connector with butterfl y valve
3 Extension (30 mm, for water heaters 30 l)
4 Hand shower with retainer
5 Spout with jet controller
6 Tap body
7 Lever
8 Changeover control spout - hand shower
9.
Installation conditions
The tap is intended for a static pressure of up to 0.6 MPa. Install
a pressure reducer upstream of the tap in the water mains if the
static pressure is higher.
10. Installation
Thoroughly fl ush the cold water supply line.
»
Debur the pipes if you have reduced them.
»
1
2
3
4
5
7
6
Eco
55
65
35
85
°C
comfort
MEK | MED | MEB |
9
Advertenties
Hoofdstukken
Inhoudsopgave
