OPERATION
GENERAL INFORMATION
OPERATION _____________________________________________ 8
1.
2.
Safety ____________________________________________________________8
3.
4.
Operation ________________________________________________________8
5.
6.
What to do if... __________________________________________________9
8.
Safety ____________________________________________________________9
9.
11. Installation ______________________________________________________9
1.
General information
Chapter Operation is intended for users and contractors.
Chapter Installation is intended for contractors.
Please read
Read these instructions carefully and retain them for
future reference. If the appliance is passed on to a third
party please hand these instructions to the new user.
1.1
Key to symbols
1.1.1 Symbols in these instructions:
In this documentation you will come across symbols and highlights.
These have the following meaning:
Please note:
!
Information concerning an existing risk. Damage can
occur to the appliance or the environment. Material
losses can also result.
8
|MEK | MED | MEB
Please read
Read the text next to these symbols carefully.
Passages preceded by these symbols indicate procedures you
»
must follow; these are described step-by-step.
- Passages with this symbol indicate lists.
2.
Safety
Risk of scalding or burning!
This risk only exists at temperatures above 43 °C.
Limescale can block the tap outlet.
!
Never close off the tap outlet, and never use jet
!
controllers, aerators, fl ow limiters or hoses with jet
controllers.
Never twist shower hoses.
In all of the instances mentioned above the water heater is under
mains pressure. As it is not designed for this it could be damaged.
3.
Appliance description
The mixer taps are intended for operation with an open vented
(zero pressure) oversink water heater.
The pivoting spout is fi tted with a jet controller, except MED.
The volume of water expands as the water heater
is heated up. Expansion water drains out of the tap
outlet. This is a necessary and normal process.
4.
Operation
You can draw water by pulling the lever forward.
By turning the lever sideways you can set the required temperature
through mixing cold and hot water. Turning it to the right releases
cold water, turning it to the left releases hot water.
With the MEB mixer tap you can switch between the pivoting spout
and the hand shower. For this, press the changeover control while
drawing water.
After drawing has fi nished the tap automatically resets itself so
that next time water is drawn, it will fl ow from the pivoting spout
again.
www.stiebel-eltron.com