Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Attachment swivel wheels
Attach the feet supplied to the underside of the heater (see
picture):
Turn the heater upside down. Place a blanket (or something
similar) under the heater to prevent damage!
Push both feet (each with 2 swivel wheels) into the recesses on
the base of the heater until you hear them click into place.
Return the heater to the upright position.
Set-up and operation
1.
Control light 'heater on'
2.
Control light 'low output'
3.
Control light 'high output'
4.
Control light heating
5.
Thermostat symbol
6.
Button for selecting low/high
output
Check to make sure the main switch is set to O (off).
Check that the heater is stable and upright, in line with instructions.
Now insert the plug into the 220/240V socket.
Set the main switch to I (on). The control light 'heater on' (POWER) lights up.
Now press the activation button (7). The display will show room temperature
and the set output (LO=low, HI=high).
At the factory, the thermostat is set to 35°C, the timer to 00.00 and output on
"HI"=high.
Setting temperature
Press the activation button again; the display will show a blinking '35' and '°C'.
Press the 'higher' or 'lower' button to set the desired temperature: every time
you press the button, the set temperature will increase/decrease by 1 degree.
The temperature can be set between 5 and 45°C. Once the desired temperate
appears on the display, you can stop. The set temperature will blink for 5
seconds on the display, then the room temperature will be displayed again. The
thermostat is now set and the thermostat symbol (°C) will be lit up. Once the
heater begins to heat, the Heating control light (4) will light up; it goes out when
the heater shuts down.
7.
Activation button
8.
Display
9.
Timer symbol
10. 'Higher' button
11. 'Lower' button
12. Main switch
29
Advertenties
Inhoudsopgave
